Arizona State Car Window Flag 12×16 Inch – Printed Polyester – 17 Inch White Plastic Flex Pole State of Arizona Car Flag

The window clip is a spring-tension jaw that grips the top edge of your car window glass when the window is partially rolled down — typically 2 to 3 inches is enough to seat the clip securely. The clip has two jaws: the outer jaw rests against the outside surface of the glass and holds the pole against the exterior of the door, while the inner jaw sits inside the window channel to keep the clip from sliding. No tools, no adhesive, no drilling, and no modification to the vehicle are required. To mount: roll down your window 2–3 inches, slide the flag onto the pole, then hook the clip over the glass edge from the outside and press it firmly until it seats. Give the pole a gentle outward tug before driving to confirm it's secure. To remove: press the clip jaws together slightly and lift it off the window edge.

The window clip is designed to grip the glass edge rather than the painted door panel, and the contact surfaces of the clip jaws are smooth plastic rather than metal. Under normal, correctly-installed use at recommended speeds, the clip should not scratch the window glass or the door paint. However, if the clip slips or vibrates against the window frame or door panel during driving — which can happen if the clip is not fully seated, if driving above 45 mph, or if the window glass has an unusual profile — repeated contact may cause fine scratches over time. For the cleanest installation, ensure the clip is seated fully on the glass edge, not resting partially against the rubber window seal or door frame. If you drive a vehicle with frameless windows (some two-door coupes and convertibles), the clip may not seat as securely — test at very low speed before full use.

At driving speed, a flag on a rigid pole transmits the full aerodynamic force directly to the window clip and the base of the pole — the two weakest points in the assembly. A rigid pole at 35–45 mph will either snap at the base or pop the clip off the window as the aerodynamic load peaks on gusts and acceleration. A flex pole absorbs that force by bending: the tip deflects backward as speed and wind load increase, which converts the direct bending stress into a smoother distributed flex along the pole's length. When you slow down or stop, the pole springs back upright. The trade-off is that a flex pole at high speed will be bent well past vertical — which is why the under-45-mph advisory exists. The flex pole doesn't make high-speed flying safe; it just means the pole survives moderate-speed driving far longer than a rigid pole would.

The window clip system is compatible with the vast majority of standard passenger vehicles — sedans, coupes, pickup trucks, SUVs, and minivans — that have conventional framed windows where the glass slides up and down inside a door frame. The clip seats on the top edge of the window glass when it is rolled down 2–3 inches. Vehicles where fitment may vary include frameless-window convertibles or two-door coupes (where the glass has no surrounding frame at the top edge), trucks with very thick door panels where the window edge is recessed deeply, and older vehicles where the window glass edge profile is unusually thin or thick. If you're unsure, the clip is easy to test at no risk: seat it on the glass edge while parked, and check that it grips firmly before driving.

Arizona's state flag was designed in 1917 by Captain Charles W. Harris of the Arizona National Guard. The flag is divided horizontally into two halves. The lower half is a solid blue field matching the same shade of blue used in the US flag. The upper half features thirteen alternating red and gold sunbeams radiating outward from the center — thirteen for the original thirteen colonies, and the red and gold specifically referencing the colors carried by Spanish conquistadors who explored the Arizona region in the 16th century. At the center of the flag, where the two halves meet, sits a large copper-colored five-pointed star. The copper star represents Arizona's identity as the nation's largest copper-producing state — a major element of the state's economy and history since Spanish colonial times. The flag was officially adopted by the Arizona State Legislature on February 27, 1917, five years after Arizona became the 48th state of the Union on February 14, 1912 — Arizona's Statehood Day.

It's not recommended for extended periods. While the clip and pole are designed to hold securely during driving and normal parking, leaving the flag assembly mounted overnight or over multiple days exposes it to several issues: sustained UV from Arizona's intense sun will accelerate color fading on the polyester flag, particularly if parked in direct sun; heat buildup inside a closed vehicle (which can reach 130–150°F in Arizona summers) can warp the plastic flex pole; and wind gusts from passing vehicles and overnight weather can stress the pole and clip beyond normal driving loads. For best results, remove the flag and pole after each use, store them inside the vehicle or at home, and reinstall at your next event. The assembly takes under 10 seconds to mount and dismount, making this a practical habit rather than an inconvenience.

Return within 30 days in original, unused condition for a full refund — prepaid return label provided, no questions asked. If your car flag kit arrives with a printing defect, a cracked or bent pole from shipping, or a window clip that fails to grip properly on first use, contact us within 30 days for a free replacement with no return shipping required on defective items. Note that pole breakage resulting from use above the recommended 45-mph speed limit is not covered under the defect policy — the speed advisory is a genuine engineering constraint, not a legal disclaimer.