Delaware State Flag 8×12 Ft – Double Sided Reverse Print On Back 200D Nylon – Rope Thimble Brass Grommet Stitched Edges Fade Proof Sharp Colors – Large Size Indoor/Outdoor Delaware Flag

This 8x12 flag is proportioned for flagpoles in the 30 to 40 foot range, consistent with the standard one-quarter to one-fifth ratio used for commercial flagpole sizing. Flying a flag this large on a shorter pole will look disproportionate and significantly increases the risk of the flag dragging or fouling on the ground in low wind. If your installation is on a pole shorter than 30 feet, our 5x8 ft Delaware flag is a better proportional fit and uses standard grommet mounting.

Yes — the rope and brass thimble header is designed to tie directly into a standard halyard rope using a secure knot (commonly a bowline). This is compatible with most commercial flagpole halyard systems, including winch-operated poles common at 30 to 40 foot heights. We recommend having the connection tied and inspected by someone familiar with flagpole rigging, since this connection carries the full structural load of the flag.

Reverse print means the dye fully penetrates the nylon during printing, so the front reads correctly and the back shows a sharp mirror image. At jumbo 8x12 scale, this construction is essential rather than optional — a genuine double-sided flag of this size, with two fabric layers and a block-out liner, would be dangerously heavy when wet and would put excessive strain on the pole, halyard, and rigging. Single-reverse construction keeps the flag light enough to fly safely while remaining vivid from both sides.

Yes, though at 96x144 inches this is best suited to large indoor spaces with adequate ceiling height and wall space — think arena concourses, large auditoriums, convention center backdrops, or expansive corporate lobbies. The rope and thimble header can still be used for hanging if anchored to a secure support, or the flag can be mounted flat using its full canvas area. Given its weight, we recommend professional installation for indoor mounting at this scale.

Because this flag is structurally rigged rather than simply clipped on, we recommend monthly visual inspection of the rope, thimble ring, and fly end, with closer attention after any high-wind event. Catching early fraying at the rope or thimble connection point is significantly more important at this scale than on smaller grommet-mounted flags, since the rigging itself bears the full load of the installation.

You can return the flag within 30 days in original, unused condition for a full refund — a prepaid return label will be provided. If the flag suffers from a manufacturing defect (such as a faulty thimble, misprinted colors, or unraveled stitching out of the box), we will replace it free of charge within 30 days. Normal outdoor wear at jumbo scale — such as fly-end fraying from sustained wind exposure — is the expected lifecycle of a flag this size and is not covered as a manufacturing defect.